Connecting the world…

mas

Aruba MAS – Tunneled node

Today I played a bit with an Aruba Mobility Access Switch with Tunneled Node configuration to a Aruba Mobility Controller. More information on Tunneled Node can be found here.

The configuration is straight forward. You need to configured a tunneled-node profile on the MAS and associate the access ports on the MAS to a VLAN, which is also present on the controller. I already have a controller in place and I would like to use some access ports for guest users with captive portal capabilities. I already setup a SSID with captive portal capabilities, so I use the same AAA profile on the controller for the tunneled-node clients.

I created the following configuration on the Aruba MAS.

ip-profile
default-gateway 10.10.75.254
controller-ip vlan 75
!
interface-profile tunneled-node-profile “tunnel-prof”
controller-ip 10.10.50.150
mtu 1300
!
interface-profile switching-profile “vl150-prof”
access-vlan 150
!
interface-group gigabitethernet “vl150-group”
apply-to 0/0/1-0/0/22
tunneled-node-profile “tunnel-prof”
switching-profile “vl150-prof”

The IP-profile defines the controller-ip of the MAS and the default-gateway configuration to access the Aruba controller (10.10.50.150). A switching profile is configured with access vlan 150 and the tunneled-node and switching-profile are bound to switch ports 0/0/1 to 0/0/22.

On the controller you only need to enable wired access and assign the AAA profile, which you also use for the guest SSID.

aaa authentication wired
profile “guest-aaa_prof”

A guest devices gets an IP address assigned from VLAN 150, located behind the corporate Aruba Mobility Controller when I connect a device to switch port 0/0/1. The guest-aaa_prof is assigned to the device/user. This redirects the user to the captive portal to enter login credentials. You can also configure user derivation to assign different VLANs to the connected devices behind the Aruba MAS.